Steering Column: 3/4 steel shaft hung on pillow block
Gauges: tach,vac.,oil, temp, spedo, air bag press
Pedals: Two gas and brake
Noise & Heat Insulation: Glass and foam board
Seals & Gaskets: Nothing but the best, Felpro
A/C & Heat: Old under the dash AC
Body Mods: chop chop
Lights: Sealed beam high and low,tail,brake
Audio & Electronics
2×4 custom frame not sure of the wheel base yet. Straight axle in front on single air bag, about a 10 in. kick up on the front end with the rear frame rails pass’in under the rear end. I plan on chop’n the roof and sectioning the cab 5 inches. I’m going to put bomber seats on the floor. Got a 350 small block T.P.I. with a turbo 350 trans. Shes a tail dragger.
History of this Vehicle
A friend had it sit’in by his gravel pit and wanted to clean the place up a bit and I asked him if I could have it and he give it to me. Under the condition that I give a ride in it on a cruise on the Miss. gulf coast. I told him that I would go one better then that. When I get it run’in he can drive it on the coast cruise.
Plans for this Vehicle
Paint it semi gloss black with white spoke wheels with skinny tires on the front end and fat tires on the rear.
Sponsors & Special Thanks
I want to thank my friends at Dumb and Dumber salvage at wheats curve in Picayune Miss.. They have been a real big help on this project. Could not have done it without them.