member since: Dec '08 |
last login: about 1 year ago
sticker wall
No Notes yet
No Videos yet
Homebuilt Turbo Exhaust Manifold - Part II
posted in: malibu dave's garage, news on November 13, 2009 at 05:25 PM
comments:
I am redesigning how I would piece together my turbo manifold. The design shown in the picture below became impractical. I am now using schedule 40 weldable elbows and another…
comments:
I am redesigning how I would piece together my turbo manifold. The design shown in the picture below became impractical. I am now using schedule 40 weldable elbows and another…
Homebuilt Turbo Exhaust Manifold
posted in: malibu dave's garage, news on January 11, 2009 at 10:34 PM
comments:
tags: t4, turbo, turbocharger, 68, 70, t70, sbc, v8, chevy, chevrolet, small block
I have been working on designing and building a single turbo manifold to work on my 1978 Malibu. This system will be built on the cheap. It will not be…
comments:
tags: t4, turbo, turbocharger, 68, 70, t70, sbc, v8, chevy, chevrolet, small block
I have been working on designing and building a single turbo manifold to work on my 1978 Malibu. This system will be built on the cheap. It will not be…
12" B-Body Rotor on a G-Body Spindle
posted in: malibu dave's garage, news on January 10, 2009 at 11:45 PM
comments:
Mocked up a B-Body Rotor on a modified (cut the caliper ears off) S10 spindle. The rotor mounted up fine, but there is only 1/4” clearance between the rotor and…
comments:
Mocked up a B-Body Rotor on a modified (cut the caliper ears off) S10 spindle. The rotor mounted up fine, but there is only 1/4” clearance between the rotor and…
